Sondersiphon pressure side, transparent  item No. 100400

The pressure side AquaKlima-Sondersiphon serves as drainage of HVAC units in wet areas in accordance with the terms of the air-conditioning techology.

The accruing condensation accumulates in a base tub then will run through a drain connection in the over pressure siphon (drain trap).Prior to commissioning, the siphon (drain trap) should be filled with water and be checked and cleaned through the sealing cap at regular intervals.

Each air or ventilation device which produces over pressure must be equipped with a Sondersiphon to ensure trouble-free operation.

To each drainage outlet a Sondersiphon should be installed separately so it can slow down freely (hygiene).

The Sondersiphon is produced from non-organic polypropylene and is resistant to frost and heat, not frost proof. This you can achieve with the help of our Siphon-trace heating.

The crystal-clear, transparent pipes produced from highquality material (17 and 18) offer an essential maintenance advantage and therefore cost savings. They permit the siphon to be observed and by this means the hygienic condition of the siphon and the unit can be monitored without effort. Next to this, the condensation flow within the siphon can be well observed. So far, the siphon had to be unscrewed and illuminated, possibly causing operating units to be shutdown. Furthermore, and especially with the overpressure drain trap, the essential water column can be detected and by this way the maintenance effort will be reduced. As it may be necessary, water can be refilled through the screw cap. Measuring even operating pressures within a unit can be carried out easily and without great technical effort due to the difference of the two water columns. With regard to hygiene requirements, our transparent Sondershiphons are applied with increasing utilisation in hospitals, laboratories, clinics, universities, etc. and have been tried and trusted for years.

Technical information:

1:  Rubber sleeve diam. 30/50
for connection ¾ “ – 1” 

2:  Rubber sleeve diam. 40/50
for connection 1 ¼” 

3:  Connection pipe diam. 40/40
for connection 1 ½” (sealing) 

4:  Coupling nut 1 ½” (5 pieces) 

5:  Wedge sealing ring diam. = 40 mm
(5 pieces) 

6: Bend joint diam. = 40 mm, 90° 

10:  Return valve with outlet 

11:  Sealing cap 1 ½” 

13:  Screw cap 2” 

14:  Bend diam. = 40 mm, 180° 

17:  Extension pipe diam. = 40 mm,
transparent

18:  Immersion tube, diam. = 40 mm

19:  Flat seal 2”

The siphon connection piece is suitable for all outlets ranging from ¾“ up to 1½“ (see installation manual). Larger or smaller connections are available upon request.

Further installation of the outlet can be assembled with commercially available drainpipes, without any difficulty.